Description
Main Feature
Good adhesion to concrete substrates
Diluted with water, green and environmentally friendly, low VOC emissions
Low odor and easy to construct
Detailed introduction
water-based epoxy primer is a water-diluted epoxy primer, which is composed of water-based epoxy curing agent, epoxy resin, deionized water and a small amount of additives.
product information
The material is divided into two components: A and B.
Component A yellow transparent liquid 18kg/barrel
Component B colorless transparent liquid 6kg/barrel
Ratio: A component: B component = 3:1
Packaging: Printed metal packaging drum. It is recommended to stack it in three layers when stacking.
Storage: Storage temperature 5-35℃, store in a cool, ventilated, dry warehouse; keep away from fire and heat sources; prevent direct sunlight; keep containers sealed
Technical data
Status: Uniform, no lumps, no impurities
Bonding strength: ≥2.5MPa
Drying time: Surface dry: less than 6 hours
Hard work: less than 36 hours
(Temperature is 25℃, relative humidity is 50%)
Grassroots requirements
The compressive strength of the concrete floor should be ≥20Mpa, the tensile strength should be ≥1.5Mpa, and the flatness should be ±4mm/2m based on ruler. The base surface must be dry, clean, and free of oil and other pollutants.
Construction Tips
Construction should be stopped when the temperature falls below 10°C
The flatness and density of the substrate have a certain impact on the coating amount, drying time and recoating interval.
Construction Conditions
Ground base temperature: 10-35℃
Construction environment temperature: 10-35℃
Ground base moisture content: <8%
Relative humidity of construction environment: <80%
Construction methods/tools
Dilution: water dilution
Construction method: Roller coating, scraping coating, spraying can be used. Pay attention to even application without accumulation or leakage.
Tools: push knife, roller brush
Instructions for use
Surface treatment: Before construction, dust, sand, cement laitance, grease, old coatings, etc. should be removed from the base surface, and polished to form a rough surface to open the capillary pores on the base surface.
Theoretical dosage: about 0.1 kg/square meter, it may vary slightly depending on the looseness of the substrate
Instructions for use: Mix the main agent and the curing agent at a mass ratio of 3:1, and stir mechanically for 2 minutes until the mixture becomes uniform and creamy. Then add water to dilute and stir evenly. When painting the first coat, the amount of water added is 50% of the total amount of paint and curing agent. When painting the second coat, the amount of water added is 30-40% of the total amount of paint and curing agent.
Precautions
For safe use of the product, please request the product safety data sheet (MSDS) from the manufacturer.
Construction workers should strengthen safety protection when using this product, and the construction environment should be kept ventilated.
For any unspecified matters, please contact local distributors or directly contact the factory.
First-aid
Skin Contact: Wash with plenty of water and remove contaminated clothing and shoes
Eye contact: Rinse with running water or saline, seek medical attention in serious cases
Inhalation: Move to fresh air and keep respiratory tract open. If you feel unwell, seek medical advice.
Ingestion: Clean up leftovers in the mouth, induce vomiting, seek medical attention
Fire-fighting measures
Hazardous characteristics: non-flammable
Hazardous combustion products: carbon monoxide, carbon dioxide, etc.
Fire extinguishing methods and fire extinguishing media: Move the container from the fire scene to an open area as much as possible. Fire extinguishing media: dry powder, sand